good luck
tim
Check for 12 volts on the fuses with a test light or meter. Next test for 12 volts at the headlight harness at the bulbs. Trace the harness and pin test all harness connections. If all is good I'd replace the DLR module.
More than likely you have a bad headlight high/low beam switch. Check the bulb sockets with a volt meter.
check switch that activates headlights. I only have low beams on one of my cars and its because the switch is busted.
replace the bulbs.
if you don,t have low beam then it could be the dimmer switch is bad ! if the fuse was bad then you would not have any high beam either ! check the dimmer switch because it,s what changes the lights from high to low and low to high beam !
I bought a used car yesterday (2006 Sebring) and didn't realize until the sun went down that BOTH low beam headlights were out. I stopped by a local store and bought two new headlights. Much to my surprise, they STILL don't work after replacing them - the high beams work and all other lights seem to work. I pulled the fuses and they are good - there is a fuse for low beam left, low beam right, high beam left and high beam right - all good. There is a DRL relay and some other stuff. I tried jiggling the wires - but no matter what, can't get the low beams to come on.
